Blackbody light not supported by this feature

carolyn_blake@gspnet.com · Post by **carolyn_blake@gspnet.com** » Wed Apr 01, 2009 8:44 am

I read the tutorial and have been trying to apply light to materials all afternoon without avail. I have made sure that the faces are not reversed. No matter what kind of material I try, I get "blackbody light not supported by this feature." Can you break this down step by step? What am I doing wrong?

Pibuz · Post by **Pibuz** » Wed Apr 01, 2009 11:34 am

..perhaps posting the scene would help a little..

Glad to have you here Carolyn!

carolyn_blake@gspnet.com · Post by **carolyn_blake@gspnet.com** » Thu Apr 02, 2009 9:15 am

thanks for getting back to me. I think I figured it out---I was trying to save the preset (and that's when the message popped up) but it wasn't necessary to do so. If I select the preset and then use the paint bucket to apply the material without saving, it's fine.

Thanks for trying to help, though!

Pibuz · Post by **Pibuz** » Thu Apr 02, 2009 7:39 pm

You're welcome. Have you read the SkIndigo FAQ part1? perhaps it could be useful for you to start..