Indigo Renderer Forum

Hi all,
I am coming from the VUE world. I've been impressed by indigo's archviz capabilities.I decided to give it a try, but after couple of hours later still ant figure out, how to apply materials as I can't see any material or object browser. Probably a stupid question, but if anybody could give me any hint, I would be very grateful. Can't believe i am so dumb I used SketchUp exporter....
Thanx a lot

Ailig

You need to double click on the sketchup material to open skindigo material editor

Etienne

Have you tried the buttons on the SkIndigo toolbar? Maybe you did not install SkIndigo correctly. Are on you on Mac or PC?

Oh, and you really should go through the tutorials on the SketchUp documentation page...
http://www.indigorenderer.com/documentation/sketchup

Thanx Galinette and Whaat,
i am slowly getting somewhere. It is just coming from VUE with (for me) super easy and efficient gui I find this a little bit tricky, for sure i will go through tutorials....thanx again....
Ailig