Page 1 of 1
Solidworks Exporter ?
Posted: Thu Jun 07, 2007 3:00 pm
by jeffr
Wondering how much interest there is in a direct from Solidworks exporter.
I have been working diligently learning Solidworks API programming with the expectation to create an exporter.
Posted: Thu Jun 07, 2007 3:37 pm
by Zom-B
right question, asked at the wrong place...
with no Solidworks Exporter not many Solidwork Guys are around here
try to ask in some Solidworks specialized Forums...
Show/tell
them about Indigo and your plans for an Exporter!
Posted: Tue Jun 12, 2007 4:12 am
by Kram1032
...or ask Big Fan
... or look arround through current posts
Posted: Wed Jun 13, 2007 11:38 am
by xrok1
please please make a solidworks exporter.
i'm sure you'll get tons of response. i've been searching for years for a way to get a descent render out of solidworks. photoworks sucks and their whole material system sucks as you've probably discovered if you've spent time with it.
it would be an answer to many prayers if an excellent renderer like yours would work with SW the design possibilities are endless.
Finally the best design software could be teamed with a worthy renderer.
P.S this would make a good poll for your home page.
Posted: Wed Jun 20, 2007 7:55 am
by Slobodan
I vote for SW exporter as well.
I was trying to do it myself but I'm just too busy..
Posted: Wed Jun 20, 2007 8:14 am
by jeffr
Things are progressing. I have it exporting the models. Just need to get the camera, lighting and materials stuff going.
Posted: Wed Jun 20, 2007 3:00 pm
by xrok1
excellent
Posted: Tue Jun 26, 2007 4:03 pm
by xrok1
P.S please please avoid ":evil: PhotoWorks
" alltogether!!!!
Posted: Mon Jul 23, 2007 5:47 am
by jeffr
Check new thread for SolidWorks Exporter